Burg Wächter secuENTRY easy plus 5652 Mode D'emploi page 38

Setting the time:
Not available in the standard function.
Setting the date:
Not available in the standard function.
Set-up submenu
General system settings
Register
After a replacement of the cylinder or the keypad, the two units have to be
newly aligned, so that they can resume communication.
Registration of a keypad
• Switch on the keypad using the key
• Then press FUNC; "Menu / Code Change" appears.
• Use keys 1 or 2 to scroll until you reach the "Administrator menu"
• Confirm with
• You can now use keys 1 or 2 to scroll until you reach the Admin. menu
"Set-up".
• Confirm with
• You can now use keys 1 or 2 to scroll until you reach the Admin. register
Set-up menu.
• Confirm with
• Enter the valid admin. code of the unit to be programmed.
• "Data have been saved" is displayed after a successful registration.
Attention! Please make sure that no other powered secuENTRY unit is
placed within direct reach of the device during installation of a new keypad
or cylinder, as by mistake such unit could be addressed instead of the
intended one. When in doubt, disconnect these units (remove batteries).
Reorganize
The use of this function is recommended when several users have
been deleted.
• Switch on the keypad using the key
• Then press FUNC; "Menu / Code Change" appears
• Scroll using the 2 key until the Administrator menu appears
• Confirm with
• Scroll using the 2 key until the "Set-up" menu item appears
• Confirm with
• The menu item "Reorganize" appears.
• Confirm with
• Enter the administrator code in order to acquire the authorisation
for programming
• "Reorganization is running" appears
FP reset submenu
(Function only active with ENTRY Fingerprint and ENTRY KP FP keypad)
42 | English
.
.
secuENTRY easy