Burg Wächter secuENTRY easy plus 5652 Mode D'emploi page 41

secuENTRY easy plus cylinder assembly
n
The installation of the secuENTRY easy plus cylinder is explained below.
Please read these assembly instructions carefully before installation.
Note:
The base size of the cylinder is 30 mm per side. The cylinder has a special
latching system on the inside and an adaptor set is included for the outer
knob, which enables you to use the cylinder for door thicknesses up to
119 mm (61/59, measured from the centre of the forend screw). No prior
adjustment is necessary. The appropriate screws are included with your set to
fit the adaptor lengths.
When delivered, the cylinder inner knob is completely closed (to the smallest
door thickness). Before you insert the cylinder into the door, you should
adjust it to your door thickness.
The inner knob is loosened and fixed by means of an integrated grub screw
in the rotary knob.
Attention! Never pull the inner knob completely off the shaft, as in
this case the electronics will be destroyed! The grub screw, which
ensures the catch on the shaft, may only be loosened slightly and
always remains in the plastic knob. The grub screw serves as a
pull-off protection!
Take care during assembly. Avoid impacts or sudden movements. The lock
should not be greased or oiled.
When installing the cylinder, proceed as follows:
1 Rough assessment of door thickness (incl. fittings)
2 Pull the outer knob off the shaft, move the inner knob over the locking
system (distances 2.85 mm) to the desired dimension.
30 mm adjustment range
3 Depending on the door thickness, you have the option of fitting adaptors
on the outside to improve the guidance of the emergency key.
secuENTRY easy
Schematic diagram
Inner knob
Internal knob adjustment
English | 45