Erreka ZEUS Manuel De L'installateur page 45

Option A: an operator in the centre of the door
Position the support piece (1) for the
telescopic arm (2)
O
The telescopic arm (2) must be located
1 1
between the upright (m) and the beam (t) of
the door. If there is insufficient space, use a
curved telescopic arm and position the support
piece (1) above the support piece of the beam
(t).
Join the telescopic arm (7) to the shaft (5)
and cut off the excess part (s)
O
With the door completely open, cut off the
exterior part (s) of the telescopic arm,
respecting the level of 100mm.
INSTALLING AND PROGRAMMING
Position the support (3), the operator (4),
the shafts (5) and its supports (6)
O
Respect the level of 100mm below the pivot of
the beam of the door.
O
The shafts (5) must be horizontal.

In order to secure the support (3) to the door,
use the tools and pieces deemed appropriate
(welding, screws and nuts, etc).

To secure the operator (4) to the support (3),
use the screws and nuts supplied.
Balance the door

The operator and the attachment pieces
increase the weight of the door, meaning
it must be rebalanced. Depending on the
type of door, increase the weight of the
1 1
counterweights or tighten the balancing
springs.
ZEUS operator for up-and-over doors
41