Periodic Checks Performed Following Maintenance Operations; First Radio Remote Control Startup - Jay Electronique UC Notice Technique D'installation Et D'utilisation

6.1.1- Periodic checks and checks performed following
maintenance operations
In addition to the commissioning checks which should be performed, also check :
- That the ergonomic features of the transmitter unit have been preserved, such
as: pressure on function buttons, emergency stop button pushed in correctly,
etc...
- Response time of commands between transmission of a command and resulting
movement.

6.2- First radio remote control startup

1- Switch ON the UCR receiver.
2- Plug the UWB battery pack into UCE transmitter housing.
3- Install the electronic key on the transmitter.
4- Copy electronic key identity code in UCE transmitter, see procedure on § 6.3.4.
5- Unlock the transmitter stop palmswitch button.
6- Press the «On/Horn» button until the receiver is started up. (safety relays are
activated).
To stop the radio remote control : press the transmitter stop palmswitch button.
NB : If this procedure is not observed the transmitter indicates an error of the
type 3 flickerings (repeat procedure described on §6.3.4) or 5 flickerings
(error of stop or startup) of its red and green indicator lights.
UC 323882G
See functioning block diagram on next page
DE EN FR
-81-