Receiver And Antenna Positions - Jay Electronique UC Notice Technique D'installation Et D'utilisation

Signalling arrows are available as an accessory.
Place the different arrows on the equipment to be controlled so that each arrow
symbol corresponds to that on the associated transmitter control button.
The direction of movement of control buttons shall whenever possible be consistent
with equipment motion. Symbols shall be fixed in such positions that there is a clear
and unambiguous relationship between the action on buttons in the control station
and the corresponding direction of motion.
The arrows are available in the following versions:
4-way black/white arrows, reference: UWE003

5.4- Receiver and antenna positions

The remote control receiver UCR should be mounted as close as possible to the
control cabinet. The UCR receiver should be sheltered from shocks and weather.
 The antenna must be installed at a distance from the class 3 cables and power
components (power supply, motor, variable speed drives ...) while remaining in
an area which is favourable to radio reception.
 The receiver must be located at a height, above the operator using the transmitter,
with the antenna directed downward.
 No metal object which could form a screen should be located between the
operator and the antenna (risk of communication cut-out).
 The antenna orientation is indicated in the figure below:
 Unless a special connector such as the plug-in antenna adapter ref. OWR01
(accessory) is used, the receiver antenna should not be modified.
FR
- 7 6 -
Good
Good
UCR
EN DE
180
mm
Good
Wrong
490 mm
UC 323882G