Uwb Plug-In Battery Pack; Battery Pack Storage Precaution; Precaution When Inserting Battery Pack In Transmitter Unit - Jay Electronique UC Notice Technique D'installation Et D'utilisation

4.3- Plug-in battery pack UWB
Housing
Material
Tightness (battery pack alone)
Tightness (battery pack mounted on
transmitter)
Dimensions
Environment withstand characteristics
Storage temperature range
Fast charging time temperature storage 0°C to +35°C
Charging time
Complete charging time
Partial charging time (at +20°C) and transmit endurance available :
10 mn of charge get approximately 1 hour of autonomy
1 hours of charge get approximately 8 hours of autonomy
6 hours of charge get approximately 12 hours of autonomy
Electrical characteristic
Charge voltage
Indicator light
1 indicator light on battery pack (when charging - see next page)
1 red indicator light on transmitter when a "Low charge level" is detected.
4.3.1- Battery pack storage precaution and general
information
UWB battery pack must be stored charged, in a proper and dry area at room
temperature, and in all cases in accordance with specified temperature range on
above table. Self-discharge is estimated at 15% the first month and then low (it is
mandatory to recharge the battery pack every 6 months mini.).
The number of full charge cycles is 300 minimum (without damaging the battery
pack capacity).
4.3.2- Precaution when inserting battery pack in
transmitter unit
Whenever changing the battery pack, check
that is properly secured in its housing in the
back of the transmitter.
If not, a type 5 fault caused by power supply
micro-cutouts can occur (following fault list
generated by the transmitter)
UC 323882G
ABS, black
IP40
IP65
40x96x23 mm
-20°C to +35°C
7 hours (if battery pack is totally discharged)
5 VDC (by UCCU charger)
Insertion of battery pack
in the back of transmitter
DE EN FR
-73-