Jay Electronique UC Notice Technique D'installation Et D'utilisation page 94

Servicing the UCR receiver :
Check the following points:
- Wiring of receiver to electrical unit on machine.
- Control relay contacts.
- Correct operation of stop circuits, active and passive.
- Condition of cover seal, tightening of screws and cable glands and
tightness of antenna.
- If accessory OWR01 (external BNC antenna connector) is used,
check the antenna connection and check that it is clean and free of
any oxidation.
- Clean the receiver by eliminating any foreign matter.
Only use non aggressive cleaning product on base of soapy
solution.
- To check operation of the active stop function, simply press the
transmitter stop palmswitch button. Receiver safety relays should
immediately de-energise.
- To check operation of the passive stop function, simply remove
the electronic key or battery pack from the transmitter or wait until
"Standby" function duration is exceeded ; receiver safety relays
should de-energise within 2 seconds.
FR
- 9 4 -
EN DE
UC 323882G