Original Accessories / Tools; Preparing The Product For Use; Connecting The Compressed Air Source; Loading The Magazine - Parkside PDT 40 D3 Instructions D'utilisation Et Consignes De Sécurité

Safety of the fastener driving tool / Preparing the product for use / Operation

Original accessories / tools

Use only the accessories and attachments
detailed in the operating instructions.
The use of fasteners or other accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.
Always have your air-powered tool
repaired by a professional using only
original spare parts. This will ensure the
air-powered tool remains safe.

Preparing the product for use

NOTE: always wear the protective goggles supplied
before putting the tool into operation. Remove the
protective film from the protective goggles before
using for the first time.
Connecting the compressed
air source
NOTE: The compressed air tacker must only be
operated with cleaned, oil-misted compressed air
and must not exceed the maximum operating pres-
sure of 8 bar. The compressor must be fitted with a
pressure reducer in order to regulate the operating
pressure.
Connect the device to a suitable compressed
air source.
1. To do so, press the compressed air hose quick-
release coupling (not included in the scope of
delivery) on the ¼ threaded nipple
compressed air tacker.
Locking is automatic.
2. Connect the other end of the compressed air
hose to the (filter) pressure reducer on the com-
pressor.

loading the magazine

1. Press the magazine lever
azine cover back to its stop position.
of the
4
and pull the mag-
5
2. Insert the corresponding fastener (nails, see
Fig. B or staples, see Fig. C) into the magazine
. The tacks must be put on the rail of the ma-
6
gazine .
6
3. Slide the magazine cover forwards until it locks.

Operation

Load the magazine
tacker as described in the chapter "Loading the
magazine".
Use the pressure reducer to set the correct
operating pressure.
Ensure that the permissible operating pressure
of 8 bar at the device is never exceeded.
Operating pressure that is too high does not
provide any performance increase, but only in-
creases compressed air consumption and ac-
celerates wear on the device.
Switch on the compressor.
Allow the compressor to run once long enough
until maximum tank pressure is reached and the
device is switched off.
Place the compressed air tacker on the workpiece
and press the trigger
NOTE: The compressed air tacker
is equipped with a trigger lock
The fastener will only leave the device
when the mouth of the compressed air tacker is
pressed against the workpiece and the trigger
is actuated.
Check that the fastener has been driven in cor-
responding to the work requirements.
– If the fastener is protruding, increase the air
pressure in 0.5 bar increments.
– If the fastener is too deep, decrease the air
pressure in 0.5 bar increments.
As an alternative, you can accelerate the work
by keeping the trigger
Set the compressed air tacker against the work-
piece.
Press the device against the workpiece until the
mouth touches it. The fastener will leave the
10
device.
As long as the trigger
time the mouth touches the workpiece one
10
fastener will leave the device.
of the compressed air
6
.
2
9
depressed.
2
is kept depressed, each
2
GB/IE
.
2
9