Initial Use; Mounting The Product; Installing The Product - LIVARNO LUX HG00394A Instructions De Montage

Only use the same type of batteries /
rechargeable batteries. Do not mix used and
new batteries / rechargeable batteries.
Remove batteries / rechargeable batteries if
the product will not be used for a longer
period.
Risk of damage of the product
Only use the specified type of battery /
rechargeable battery!
Insert batteries / rechargeable batteries ac-
cording to polarity marks (+) and (-) on the
battery / rechargeable battery and the
product.
Clean the contacts on the battery / rechargea-
ble battery and in the battery compartment
before inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.

Initial use

Mounting the product

Remove the individual parts from the packag-
ing and assemble the product as shown in
Figure A. There are two options: the spacer
tube will make the product approx. 42 cm
3
(on IAN 311685); approx. 34 cm
(on IAN 311689); approx. 51 cm (on IAN
10 GB/IE/NI
311687) tall (see Fig. B), the spacer tube
will make it approx. 29 cm (on IAN 311685);
approx. 24 cm (on IAN 311689); approx.
34 cm (on IAN 311687) tall (see Fig. C).
Insert the selected spacer tube
the designated opening on the solar module
(see Fig. A).
Then insert the ground spike
of the spacer tube

Installing the product

Note: The product can be installed without a
power source.
Only use the product with the included
ground spike .
1
Push the assembled product far enough into
the ground (lawn, flower bed) so it is stable.
Since the product relies on sunlight, consider
and observe the following points prior to instal-
lation.
1. Select a location where the solar module
is exposed to direct sunlight during the day.
2. Position the product so the solar module
not covered or in the shade (trees, roof ridge,
etc.).
3. Be sure the solar module
by another light source, e.g. yard or street
lighting, as this will prevent the product from
switching on at dusk. Remember many light
or into
2 3
into the bottom
1
or (see Fig. A).
2 3
5
5
is not impacted
5
2
5
is