Propagating The Confi Guration To Identical Devices - Carel boss Mode D'emploi

ENG
9.
Open the Main variables page.
10.
In the Probes, status, inputs/outputs table choose
whether to make the variable visible and if so where
on the page (probe status section, general section).
Click ã to compress the table.
11.
The Parameters and commands table is shown:
repeat the same operation for the variables listed.
12.
Click Save: the confi guration will be saved but is not
yet active.
Note: to defi ne the order in which the selected
variables are displayed, click Go to sort page
13.
Open the Description list page.
14.
Double click the variables to customise the code,
description and unit of measure.
15.
Click Save: the confi guration will be saved but is not
yet active.
3.4 Propagating the confi guration to identical devices
The settings on the device chosen as the "sample" can be propagated to similar devices. This saves time when
setting up complex sites.
Under Confi guration à Site confi guration
1.
à Copy confi guration select the customised
device, choose which parts of the confi guration
to propagate and choose the devices where the
settings will be copied.
Note: a complete confi guration can be exported
and used on another site using the export function
Note: previously saved confi gurations can be loaded
using the import function.
2.
Click Save: the recipient devices will be customised
with the specifi c confi guration.
3.
Restart the engine.
+040000260 - 1.1 - 06.03.2019
12