Programming Parametric Devices - Carel boss Mode D'emploi

ENG
6.
The HACCP graph page behave in the same way
for standard devices, displays the graph area
with traces in progress. Under the graph is the
list of logged variables. The checked variables are
included in the graph.
Note: to add a variable from the log to the list, open
the Log confi guration page under Device confi guration
using the Quick Link .
7.
To modify the graph scale, select a diff erent range
of display in the table below (Lower limit and
Upper limit)
8. To add or remove variables from the graph, select/
unselect these in the table.
9. Click Plot: the graph will be updated.
Nota: to edit the interval displayed, click Search and
select the desired duration.

3.6 Programming parametric devices

Parametric device parameters can be edited on just one device and then propagated to devices of the same
model.
Under Installation à Device double click the
1.
device.
2.
The device detail page is shown. Click the
Parameters page.
3.
A page is shown for selecting all the categories of
parameters available for the device. Click Refresh
to update the values read by the device.
To propagate only the modifi ed parameters to
4.
devices of the same model, fi rst enter the values
in the fi elds.
+040000260 - 1.1 - 06.03.2019
14