Reely ROAD 23 80 33 Notice D'emploi page 52

 The vehicle doesn't drive in a straight line correctly
• Set straight driving at the transmitter using the respective trimming control for the steering function.
• Check the steering rods or wheel alignment setting.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
 Steering works opposite to the way the steering wheel is turned at the transmitter
• Put the reverse switch for steering into the correct position.
 Driving works opposite to the movement of the throttle/brake lever at the transmitter
Correct: The vehicle has to drive forwards when the throttle/brake lever at the transmitter is pulled towards the handle
and back when the throttle/brake lever at the transmitter is pushed away from the handle (see chapter 8. h).
• Activate the driving reverse setting at the transmitter.
• If the brushless motor is disconnected from the speed controller and reconnected, the alignment of the 3 connection
cables between the motor and speed controller is not correct. Simply swap two of the three cables between motor
and speed controller. This reverses the rotational direction of the brushless motor (this may not be possible for this
vehicle because the cables are soldered-in and do not have any plug connection between the motor and speed
controller).
 The steering is not functioning or is functioning incorrectly, steering lock too slight on the vehicle
• If the transmitter offers dual rate settings, check these settings (observe transmitter's operating instructions). If the
dual rate setting is too low, the steering servo will no longer react.
The same applies for the so-called EPA setting (= "End-Point-Adjustment", setting of the end positions for the servo
path to protect the servo mechanics) if present at the transmitter.
• Check the steering mechanics for loose parts; e.g. check if the servo arm is properly attached to the servo.
 Reverse driving not possible
• Check the speed controller's programming to see of reverse driving is switched on or off (programming only via
optional programming card; can be ordered as an accessory).
52