Reely ROAD 23 80 33 Notice D'emploi page 44

Set alignment for the rear wheels:
The alignment for the rear wheels is set by the
so-called tie-in-block. This is a plastics part (A)
screwed to the back of the differential.
The two metal axles holding the lower trans-
verse links are attached to the outer holes of
the toe-in block.
A toe-in block with a different distance between
these two holes can be used to adjust the toe-
in of the rear wheels.
If the scope of delivery includes one or several plastics parts (B), they are
meant for changing the wheel track at the rear axle.
The toe-in setting for the rear axle has little effect on driving behaviour. Therefore, toe-in block replace-
ment will only be important for professional drivers.
44
A
B