Replacing The Battery - MSA ALTAIR PRO Manuel D'utilisation

MSA
4.2.

Replacing the Battery

Fig. 9 Sensor and Battery Replacement
1 Sensor
2 Battery
(1) Remove the four screws securing the case halves together.
(2) Carefully remove the front cover to expose the battery.
The circuit board will remain with the back half of the case.
!
! Do not touch the display connections (two blue connectors)
(3) Remove the depleted battery and replace only with one specified in
section 5.1.
Be sure to observe proper polarity on the battery, as shown on the battery
holder.
(4) Ensure the interface and connectors for the display are clean and free of dirt
for proper operation.
If necessary, the display connectors can be cleaned with a soft, lint free cloth.
(5) Replace the front cover, making sure the sensor, horn gasket and sensor
gasket are properly seated.
Caution!
Do not over-tighten the screws; otherwise, the case may be damaged.
(6) Replace the four screws.
GB
1
2
ALTAIR PRO - Operating Manual
MAINTENANCE
37