Setup Operation - Kenwood TH-D72A Mode D'emploi

SETUP OPERATION

Function Select Mode
Press [F] to enter Function Select mode. In this mode you can scroll F–0 through
F–# by pressing or rotate the Tuning control. After accessing the
[ ]/[ ]
desired function, press [ OK], then press or rotate the Tuning control to
[ ]/[ ]
select the desired parameter.
Pressing [F], [0] ~ [9] or [ ], [#] is a much simpler method. For example,
pressing [F], [ ] switches the Shift function ON or OFF. (Refer to the keypad
explanations on pages 10 ~ 11.)
Note: You can verify the battery capacity while in Function Select mode.
Full Medium Low Very Low (recharge)
Menu Mode
Press [MENU] to enter Menu mode. In this mode you can access the desired
menu item by pressing or rotate the Tuning control and [ OK] or
[ ]/[ ]
entering digits directly from the keypad (0 ~9, A, B, C, D, E ( ),and F (#) only).
For further information, refer to "MENU MODE" {page 23}.
22