Kenwood TH-D72A Mode D'emploi page 6

Masquer les pouces Voir aussi pour TH-D72A:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRECAUTIONS
Do not charge the transceiver and battery pack when they are wet.
Ensure that there are no metallic items located between the transceiver and the battery
pack.
Do not use options not specifi ed by KENWOOD.
If the die-cast chassis or other transceiver part is damaged, do not touch the damaged
parts.
If a headset or headphone is connected to the transceiver, reduce the transceiver
volume. Pay attention to the volume level when turning the squelch off.
Do not place the microphone cable around your neck while near machinery that may
catch the cable.
Do not place the transceiver on unstable surfaces.
Ensure that the end of the antenna does not touch your eyes.
When the transceiver is used for transmission for many hours, the radiator and chassis
will become hot. Do not touch these locations when replacing the battery pack.
Do not immerse the transceiver in water.
Always switch the transceiver power off before installing optional accessories.
For safety reasons, we recommend that the battery charger be connected to an easily
accessible AC socket.
Turn the transceiver power off in the following locations:
In explosive atmospheres (infl ammable gas, dust particles, metallic powders, grain
powders, etc.).
While taking on fuel or while parked at gasoline service stations.
Near explosives or blasting sites.
In aircrafts. (Any use of the transceiver must follow the instructions and regulations
provided by the airline crew.)
Where restrictions or warnings are posted regarding the use of radio devices,
including but not limited to medical facilities.
Near persons using pacemakers.
Do not disassemble or modify the transceiver for any reason.
Do not place the transceiver on or near airbag equipment while the vehicle is
running. When the airbag infl ates, the transceiver may be ejected and strike the
driver or passengers.
Do not transmit while touching the antenna terminal or if any metallic parts are
exposed from the antenna covering. Transmitting at such a time may result in a high-
frequency burn.
If an abnormal odor or smoke is detected coming from the transceiver, switch the
transceiver power off immediately, remove the battery pack from the transceiver, and
contact your KENWOOD dealer.
Use of the transceiver while you are driving may be against traffi c laws. Please
check and observe the vehicle regulations in your area.
Do not expose the transceiver to extremely hot or cold conditions.
ii

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Th-d72e

Table des Matières