Battery Charging; Fuse Check/Replacement - Clarke Vantage 17 Manuel D'utilisation

ENGLISH

BATTERY CHARGING

NOTE
Charge the batteries when the indicator light (A or B,
Fig. 30) turns on, or when inished cleaning.
Keeping the batteries charged makes them last
longer.
CAUTION!
When the batteries are discharged, charge them
as soon as possible, as that condition makes
them last shorter.
Check for battery charge at least once a week.
CAUTION!
Batteries must be charged indoors, in a dry
environment.
Drive the machine indoors, in a dry environment (damp
1.
free), to charge the batteries.
Charge the batteries according to the following procedure.
2.
Make sure the battery charger cable is plugged into an
3.
electrical outlet that will provide voltage and frequency
according to the serial number plate/technical data (D, Fig.
31).
NOTE
When the battery charger is connected to the electrical
outlet, all machine functions are automatically cut off.
The green indicator light (B, Fig. 31) lashes when the
battery charger is charging the batteries.
4. When the green indicator light (B, Fig. 31) stays on, the
battery charging cycle is over.
5. When the battery charging cycle is over, disconnect the
battery charger cable (A, Fig. 31) from the electrical outlet
and wind it around it's housing on the machine.
6. Now the machine is ready to be used.
NOTE
For further information about the operation of the
battery charger (C, Fig. 31), see the relevant Manual.

FUSE CHECK/REPLACEMENT

Remove the recovery tank as shown in the Use chapter.
1.
2. Disconnect the battery negative terminal.
3. Remove the screws (A, Fig. 32) and remove the electrical
component box cover (B).
Check/replace the fuses:
4.
• Brush fuse (C, Fig. 32): (40 A)
• Vacuum system fuse (D, Fig. 32): (40 A)
• Solenoid valve and electronic board fuse (E, Fig. 32):
(5 A)
5. Reassemble in the reverse order of disassembly.
22
Figure 30
Figure 31
Figure 32
Operator's Manual - Vantage 17 Battery