Recovery Tank Removal; Stored Machine - Clarke Vantage 17 Manuel D'utilisation

RECOVERY TANK REMOVAL

To check the batteries, or to perform other operations, it may be
necessary to remove the recovery tank (A, Fig. 23) according to
the following procedure:
Empty the tank (A, Fig. 23) according to the procedure
1.
shown in the relevant paragraph.
2. Drive the machine on a level ground.
3. Make sure that the switches (A and B, Fig. 22) are in the "0"
position.
4. Disconnect the vacuum hose (C, Fig. 22) from the squeegee
(D).
5. Disconnect the recovery tank drain hose (E, Fig. 22) from
the bracket (F).
Open the cover (B, Fig. 23) and apply the cover stand (C).
6.
Grasp the recovery tank (A, Fig. 23) in the area (D) and
7.
slightly lift it, as shown in the igure.
8. Disconnect the vacuum hose (E, Fig. 23) from the tank, then
remove the tank (A) with the hoses (F) and (G).

STORED MACHINE

If the machine is not going to be used for more than 30 days,
proceed as follows:
Perform the operations described in the After Using the
1.
Machine paragraph.
2. Remove the recovery tank (A, Fig. 23) according to the
procedure shown in the previous paragraph, then disconnect
the battery negative terminals.
3. Reinstall the recovery tank (A, Fig. 23).
Store the machine in a clean and dry place, with the brush/
4.
pad and the squeegee lifted or removed.
Operator's Manual - Vantage 17 Battery
ENGLISH
Figure 22
Figure 23
17