Switching On And Off; Adjusting The Cutting Height; Adjust Front Wheel; Working With The Lawnmower - Grizzly ERM 1642 Trike Traduction De La Notice D'utilisation Originale

Switching On and Off

The red LED (
lease button will illuminate as soon
as the lawn mower is connected to
a power supply.
G 2. To relieve the strain, form a loop
with the end of the power cable
( 14) and hang this into the
strain relief (15).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (16) on the handle at the
same time as pressing the start
lever. Release the release button
(16).
6. To switch off, release the start
lever (2).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.

Adjusting the Cutting Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The equipment has 6 positions for setting
the cutting heigh (25-75 mm):
1. Pull the lever (9) outwards and
push it to the desired position .
2. Push the lever back in.
3. Also set the appropriate height
on the front wheel (5).
17) above the re-
Pull the lever (22) outwards and
push it to the desired position .
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 –
60 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Observe the noise protection and
local regulations.

Adjust front wheel

The lawn mower is extremely flexible and
manoeuvrable thanks to the special con-
struction of the front wheels.
These are to be adjusted according to the
specific situation as follows:
1. The alignment of the wheel is
fixed once the clamping bra-
ckets (
the wheel is desired in another
running direction, lift clamping
bracket to release it. Bring
wheel into new position and
clamping brackets snaps into
place once again.
2. Should the front wheels remain
able to move freely, lift the
clamping brackets (
do not place them in the open-
ing, but rather set them on the
plate beside it.

Working with the Lawnmower

Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
23) snaps into place. If
23) and
GB
29