Grizzly ERM 1642 Trike Traduction De La Notice D'utilisation Originale page 26

GB
• Do not lift or carry the equip-
ment when the motor is run-
ning. Risk of injury from cuts.
• Switch off the equipment and
disconnect the plug. Make
sure that all moving parts have
come to a complete stop:
- Whenever you leave the ma-
chine,
- Before cleaning the ejection
hole or removing blockages,
- When the equipment is out of
use,
- Before checking, cleaning or
working on the equipment,
- If the power cable is dam-
aged or frayed,
- if a foreign object has been
hit by the device. Check for
damage to the lawnmower
and carry out the necessary
repairs before switching on
again and working with the
lawnmower.
If the lawnmower starts to vi-
brate abnormally, an immediate
check must be carried out.
- carry out a search for dam-
age;
- perform the necessary re-
pairs of damaged parts;
- make sure that all nuts, bolts
and screws are properly
tightened.
• Do not place feet or hands
near or under rotating parts.
Do not stand in front of the
grass ejection hole during
mowing.
Maintenance and Storage:
• Ensure that all nuts, bolts and
screws are tightened firmly and
26
the equipment is in safe work-
ing condition.
• Do not attempt to repair the
equipment yourself unless you
have been trained to do so.
Any work not specified in these
instructions is to be carried out
only by customer service cen-
tres that we have authorised.
• Keep the equipment in a dry
location and out of reach of
children.
• Handle the equipment with
care. Keep tools sharp and
clean, in order to facilitate bet-
ter and safer work. Follow the
maintenance instructions.
• Wear protective gloves when
changing the cutting device.
• Regularly check the grass col-
lection device for wear and
strains. For safety reasons, re-
place worn or damaged parts.
When adjusting the blades,
take particular care to avoid
fingers being trapped between
the rotating blades and fixed
parts of the machine.
Many accidents are caused by
poorly maintained equipment.
• Check that only replacement
tools authorised by the manu-
facturer are used.
• During maintenance of the cut-
ting blades, be aware that they
can be brought into motion
even when the power supply is
switched off.
• Worn or damaged information
signs must be replaced.
• Replace worn or damaged
parts for safety reasons. Use
only original spare parts and
accessories.