Explanation Of The Symbols On The Equipment - Scheppach HL730 Traduction Des Instructions D'origine

Explanation of the symbols on the equipment

The use of symbols in this manual is intended to draw your attention to possible risks. The safety symbols and the
explanations that accompany them must be perfectly understood. The warnings in themselves do not remove the risks
and cannot replace correct actions for preventing accidents.
2x
Oil
Oil
m Attention!
18 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Please read the manual before start-up
Wear safety footwear
Wear work gloves
Use hearing protection and safety goggles
Wear a hard hat
No smoking in the working area
Do not spill hydraulic oil on the floor
Keep your workspace clean! Untidiness can cause accidents!
Dispose of waste oil correctly (waste oil collection point on site). Do not dump waste oil in
the ground or mix it with waste.
Do not remove or modify protection and safety devices.
Only the operator is allowed in the work area of the machine. Keep other people and
animals (minimum distance 5 m) at a distance.
Do not remove jammed trunks with your hands.
Caution! Switch off the engine before repair, maintenance and cleaning. Unplug the
mains plug.
Danger of bruising and injury from sharp edges; never touch danger areas when the
cleaver is moving.
High-voltage, danger to life!
The machine must only be operated by one person!
Loosen the vent bolt two revolutions, before starting work. Close before transport.
Caution! Moving machine parts!
Do not transport the device in the horizontal position!
In this operating manual, we have used this sign to mark all sections that concern your
safety.