Table des Matières
Publicité
POWR
CYLINDER HEAD
SERVICE POINTS
Cylinder head inspection
1. Eliminate:
Carbon deposits
(with a rounded scraper 1)
CAUTION:
Do not use a sharp instrument to avoid
damaging or scratching the cylinder head
or spark plug bore threads.
2. Inspect:
Cylinder head water jacket
Corrosion/mineral deposits → Clean
or replace.
3. Measure:
Cylinder head warpage
(with a straightedge and thickness
gauge)
Out of specification/score marks →
Resurface.
Warpage limit:
0.05 mm (0.002 in)
NOTE:
Place a 400–600 grit wet sandpaper on a
surface plate and resurface the cylinder
head using a figure-eight sanding pattern.
5-26
E
Publicité
Chapitres
Table des Matières
