Table des Matières
Publicité
FUEL
CARBURETOR UNIT
SERVICE POINTS
Throttle valve synchronization inspection
and adjustment
1. Check:
Throttle valve synchronization
Not synchronized → Adjust.
Checking steps:
Loosen the remote throttle stop screw
1 until untouched the screw end from
the throttle lever.
Check the each throttle valve is fully
closed.
2. Adjust:
Throttle valve synchronization
Adjustment steps:
Loosen the remote throttle stop screw
1 until untouched the screw end from
the throttle lever.
Loosen the screws 2.
NOTE:
Make sure that the throttle valves are in
the fully closed position.
Tighten the screws 2.
Screw:
2 N • m (0.2 kgf • m, 1.4 ft • lb)
Turn in the remote throttle stop screw
to the original position.
4-17
E
Publicité
Chapitres
Table des Matières
