Drive Shaft; Limit Switch - RK Rose+Krieger RK MonoLine R Manuel D'utilisation

3.3.3 Drive shaft

Fig. 7: Drive shaft
A Drive shaft (size 40)
B Drive shaft (size 60)
C Drive shaft (size 80)
D Drive shaft (size 120)

3.3.4 Limit switch

26.03.2019
The drive shaft is assembled on the pulley box and transmits tor-
ques from the motor to the linear unit.
Unlike the other sizes, the drive shaft in size 60 is not
equipped with an adapter washer.
Further information:
n Assembling the drive shaft
Fig. 8: Limit switch
A Mechanical limit switch
B Inductive limit switch
The limit switch is assembled on the side of the guide profile above
holding plates/mounting brackets and stops the guide carriage
from exceeding the defined end positions.
Further information:
n Assembling limit switches
Linear unit RK MonoLine R/RK MonoLine Z
Set-up and function
Optional modules > Limit switch
Ä Page 102
Ä Page 104
89