Best Practices - Dremel 3D40 Traduction De La Notice Originale

REMOVING SUPPORTS (IF REQUIRED)
Use needle nose pliers to remove supports that are
inside your object or hard to reach.
Removal Tool

BEST PRACTICES

1. ALWAYS USE BUILD TAPE.
2. Ensure your build platform is level before every
object.
3. Ensure spool is installed properly and can rotate
freely.
FIG. 8
4. When using your Dremel 3D40 for the first time
or after changing filament, allow Dremel 3D40 to
extrude until material is consistent with the installed
filament color.
5. It is important to watch your Dremel 3D40 begin
building objects. Your object is most likely to
experience difficulty in the beginning. Thankfully,
this is also the most convenient time to cancel
the object, clean the build platform, and start your
object again. Remain near the Dremel 3D40 during
the building process.
6. It is important to save your Dremel 3D40 packaging
as it will make re-boxing and transporting your
Dremel 3D40 easier.
7. Ensure that you store filament spools in an
environment that is not moist or too hot. It is
recommended that you do not remove the filament
spool from its airtight packaging until use.
8. Use object removal tool gently to avoid damaging
the build platform or object.
9. Whenever possible, it is best to locate your object
in the center of the build platform. Using the best
orientation for your object is critical. Ensure that
your object is located on the build platform and that
you are using the best orientation for building.
10. For steep overhangs (Less than 45 degree angle) it
is recommended to build with support.
11. Always remove the build platform before removing
the object.
12. Low speed sanding is recommended to prevent
remelting of the object.
13. The Dremel Digilab 3D Slicer software will display
the length of filament required for each object.
Compare this to the length indicated on the spool
length gauge.
25