Best Practices - Dremel 3D20 Idea Builder Consignes De Sécurité/D'utilisation

DM 2610035691 07-14_3D20 7/3/14 2:41 PM Page 35
1. ALWAYS USE BUILD TAPE.
2. Ensure your build platform is level before
every object.
3. Ensure spool is installed properly and
can rotate freely.
4. When using your Dremel 3D20 for the
first time or after changing filament, allow
Dremel 3D20 to extrude until material is
consistent with the installed filament
color.
5. It is important to watch your Dremel 3D20
begin building objects. Your object is
most likely to experience difficulty in the
beginning. Thankfully, this is also the
most convenient time to cancel the
object, clean the build platform, and start
your object again. Remain near the
Dremel 3D20 during the building process.
6. It is important to save you Dremel 3D20
packaging as it will make re-boxing and
transporting your Dremel 3D20 easier.
7. Ensure that you store filament spools in
an environment that is not moist or too
hot. It is recommended that you do not
remove the filament spool from its airtight
packaging until use.
8. Use object removal tool gently to avoid
damaging the build platform or object.

Best Practices

9. Whenever possible, it is best to locate
your object in the center of the build
platform. Using the best orientation for
your object is critical. Ensure that your
object is located on the build platform
and that you are using the best
orientation for building.
10. For steep overhangs (Less than 45
degree angle) it is recommended to build
with support.
11. To prevent build tape from peeling during
the build, wrap the build tape underneath
the build platform.
12. Always remove the build platform before
removing the object.
13. Use the home feature before unloading
and loading a filament spool. Also, it is
recommended to remove the build
platform before unloading or loading a
filament spool.
14. Low speed sanding is recommended to
prevent remelting of the object.
15. The Dremel 3D software will display the
weight of each model. You can determine
whether you have enough filament to
complete your object before building by
weighing the filament and spool then
subtracting the weight of the spool.
35