Anti-Tip Tubes - Sunrise Medical SOPUR Argon2 Notice D'utilisation

Anti-Tip Tubes

WARNING !
Sunrise Medical recommends anti-tip tubes for all chairs.
When fitting anti-tip tubes, use a torque of 7 Nm.
1. Slotting The Anti-Tip Tubes Into The Clamp:
a. Press the rear button on the anti-tip tube on the anti-tip
tube adapter, so that both release pins are drawn
inwards.
b. Slot the anti-tip tubes (1) into the anti-tip tube adapter.
c. Turn the anti-tip tubes downwards until the release pin
locks into the clamp.
d. Fit the second anti-tip tube in the same way.
2. Adjusting The Anti-Tip Tubes
To achieve the correct ground clearance of approx. 1" to
2" (2.5 cm to 5.0 cm), the anti-tip tubes must be raised or
lowered.
Press the anti-tip tube release button, so that both release
pins are drawn inwards. Move the inner tube up or down
to slot into the height holes provided. Release the button.
Fit the second anti-tip wheel in the same way. Both
wheels should be at the same height. (Fig. 4.35).
DANGER !
Sunrise Medical Recommends Use Of Anti-Tip Tubes:
If the anti-tip tubes are not fitted, or have been fitted
incorrectly, there is a risk of tipping over and of injury.
Fig. 4.35
42 42
Active Anti Tip/Flip Up
The active Anti tip is mounted on the left or right side of
the axle tube. By pushing it towards the axle tube, it can
be flipped downwards for operation, (Fig.4.36).
WARNING!
Make sure that the anti tip will lock in the final position. An
unlocked active anti tip can lead to serious injury of the
user.
Fig. 4.36
Active Anti Tip For Sport
To remove the active anti tip for sport, press the button of
the quick release pin and pull it out. Now pull out the tube
from the anti tip receiver, (4.37-4.38).
Fig. 4.37 Fig. 4.38
Argon2 Argon2 Rev.D Rev.D