Transportation In Vehicles - Breezy 300 Série Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
Note !
Make sure that your tyres have sufficient tread! Please note that you are subject to any and all traffic
laws when driving in public traffic.
Note !
Always be careful with your fingers when working or adjusting the wheelchair!
The products shown and described in this manual may not be exactly the same in every detail as your
own model. However, all instructions are still entirely relevant, irrespective of detail differences.
The manufacturer reserves the right to alter without notice any weights, measurements or other
technical data shown in this manual. All figures, measurements and capacities shown in this manual
are approximate and do not constitute specifications.

TRANSPORTATION IN VEHICLES

This product is suitable to use as a seat in vehicles as per certificate ISO/FDIS 7176-19 :2008 (E) and using the restraint
system Q straint Q-5001-T2.
A wheelchair secured in a vehicle will not provide the equivalent level of safety and security of a vehicle seating system.
It is always recommended that the user transfers to the vehicle seating. It is recognised that this is not always practical for
the user to be transferred and in these circumstances where the user must be transported whilst in the wheelchair the
following advice should be followed.
1.
Confirm that the vehicle is suitably equipped to transport a passenger in a wheelchair, and ensure the
method of access/egress is suitable for your wheelchair type. The vehicle should have the floor
strength to take the combined weight of the user, the wheel chair and accessories.
2.
Sufficient space should be available around the wheelchair to enable clear access to attach, tighten and
release the wheelchair and occupant tie down restraints and safety belts.
3.
The occupied wheelchair must be located in a forward facing position and secured by the wheelchair tie
down and occupant restraint straps (WTORS tie downs) meeting the requirements of ISO 10542 or SAE
J2249, in accordance with the WTORS manufacturers' instructions.
4.
The wheelchair's use in other positions within a vehicle has not been tested e.g. transportation in a side
facing position must not be carried out under any circumstances. (Fig. 10)
Warning There is a risk of serious injury or death if this if this advice is ignored.
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

305312315310321341

Table des Matières