Log Placement - Napoleon Fiberglow Série Manuel D'installation Et D'opération

fi nishing
EN
3.3

log placement

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
TM
Phazer logs, exclusive to Napoleon, provide a unique and realistic glowing effect that is different in every installa-
tion. Failure to follow these log placement instructions may cause sooting.
A. Place the rear log #1 onto
the locating studs on the
rear log support.
D. Position the pins on the
bottom of log #4 into the
holes on the left end of
log #1 and the left end of
log #2.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
Positioning the logs improperly will cause fl ame impingement and carboning.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. Use only
TM
certifi ed Phazer logs available from your authorized dealer/distributor.
10
W415-1071 / F / 11.16.19
B. Position the holes on the
bottom of log #2 onto the
fi bre embosses shown.
E. Place the end of log #5
on the right end of log
#1. The fork in the log
should straddle the knot
on top of the log #2.
C. Position the bottom cavity
of log #3 onto the bracket
located in the front right
corner.