Finishing; Andiron And Grate Assembly; Battery Installation - Napoleon Fiberglow Série Manuel D'installation Et D'opération

3.1

andiron and grate assembly

A. With the 2 andirons laying face down,
secure the grate overtop using two
¼-20 bolts (supplied in the manual
baggie).
B. Install the grate/andiron assembly
to the burner base using four 1 ¼"
self tapping screws (supplied in the
manual baggie).
3.2

battery installation

A.
Remove all of the logs.
B.
The battery pack is located at the rear right corner of
the burner behind the pilot. If there is room, slide the
battery pack out to the right, otherwise lift up carefully,
making sure that the wires connected to the battery
pack do not become entangled.
C.
Unfasten the velcro and replace the 4 AA batteries.
D.
Replace battery pack and log set (see "LOG
PLACEMENT" section).
3.0 fi nishing
USE ONLY ACCESSORIES
DESIGNED FOR AND
LISTED WITH YOUR
SPECIFIC LOG SET.
1
2
W415-1071 / F / 11.16.19
fi nishing
EN
9