Troubleshooting - Napoleon Fiberglow Série Manuel D'installation Et D'opération

Masquer les pouces

Table des Matières

Les langues disponibles

WARNING

•

Turn off gas and electrical power before servicing the appliance.

•

Appliance may be hot. Do not service until appliance has cooled.

•

Do not use abrasive cleaners

•

Do not paint pilot assembly.

symptom

Pilot will not light and

Battery.

/ or makes noise

Wiring.

with no spark at pilot

burner.

Loose connection.

IGNITOR

(SPARK)

Module.

SENSOR

Igniter spark gap is incorrect.

Electrode.

PILOT TUBE

A shorted or loose

connection.

Improper switch wiring.

Module is not grounded.

Pilot sparks but will

Gas supply.

not light.

Out of propane gas.

Carbon is being

Air shutter has become

deposited on glass,

blocked.

logs, rocks, media or

Flame is impinging on the

combustion cham-

glass, logs, rocks, media or

ber surfaces.

combustion chamber.

problem

Check batteries.

Verify the wire for the sensor and the wire for the ignitor are

connected to the correct terminals (not reversed) on the

module. NOTE: Sensor has 3/16" (4.8mm) connection

and ignitor has 1/8" (3.2mm)connection.

Verify no loose connections, electrical shorts in the wiring or

ground out to any metal object.

Turn the ON/OFF switch to the "OFF" position. Remove the

igniter wire from the module. Place the ON/OFF switch to the

"ON" position. Hold a grounded wire about 3/16" (4.8mm)

away from the ignitor (spark) terminal on the module. If no

spark the ignitor terminal module must be replaced. If there is

a spark the ignitor terminal is ﬁ ne.

Spark gap of the ignitor to the pilot should be 1/8" (3.2mm).

Inspect pilot assembly for a shorted wire or cracked insulator

around the electrode.

Remove and reinstall the wiring harness that plugs into the

module. Remove and verify continuity of each wire in wiring

harness.

Troubleshoot the system with the simplest ON/OFF switch.

Verify the valve and pilot assemblies are properly grounded to

the metal chassis of the appliance or log set.

Verify that the incoming gas line ball valve is "Open". Verify

that the inlet pressure reading is within acceptable limits, inlet

pressures must not exceed 14" W.C.(34.9mb)

Fill the tank.

Ensure air shutter opening is free of lint or other obstrucitons.

Check that the glass, logs, rocks or media are correctly

positioned.

Open air shutter to increase the primary air.

Check the input rate: check the manifold pressure and oriﬁ ce

size as speciﬁ ed in the instructions.

9.0