Installation Rules; Electrical Installation Rules - Faema E61 Jubilé Manuel D'installation

2. Installation Rules

Installation, dismantling, and adjustments must only be performed by qualified and authorized
technicians.
Carefully read the warnings and rules in this manual because they provide important information regarding
safe installation, use and maintenance of the machine.
Keep this booklet handy for easy reference.
• After removing the machine from its packing materials, make sure that the machine and its safety devices are intact.
• If the power supply cord is damaged, it can only be replaced by qualified and authorized technicians.
• Packing materials (plastic bags, polystyrene foam, staples, etc.) must be kept out of the reach of children because they are
potentially hazardous.
• Before plugging in the machine, make sure that the information on the nameplate (voltage, etc.) matches that of the electrical
and water systems.
• Completely unwind the power supply cable.
• The coffee machine should sit on a flat, stable surface at least 20 mm from walls and from the counter. Keep in mind that the
highest surface on the machine (the cup warmer tray) sits at a height of at least 1.2 meters. Make sure there is a shelf nearby
for accessories.
• Room temperature must range between 10° and 32°C (50°F and 90°F).
• An electrical outlet, water connections, and a drain with siphon must be in the immediate vicinity.
• Do not install in rooms (kitchens) that are cleaned with jets of water.
• Do not clean the machine with jets of water.
• Do not obstruct openings or ventilation and heat vents.
• Do not install the machine outdoors.

3. Electrical Installation Rules

Prior to installation, make sure there is a circuit breaker installed with a distance between the contacts that allows for complete
disconnection when there is a category III overload and that provides protection against current leakage equal to 30 mA. The
circuit breaker must be installed on the power supply in compliance with installation rules.
The electrical safety of this machine is only ensured when it is correctly connected to an efficient earthing system in compliance
with the electrical safety laws in force. This fundamental safety requirement must be verified. If in doubt, request that a qualified
electrician inspect the system. The manufacturer cannot be held responsible for any damage caused by the lack of an earthing
system on the electrical supply.
It is unadvisable to use adaptors, multiple plugs, and/or extension cords. If their use is indispensible, only use simple or multiple
adaptor plugs and extension cords that are in compliance with safety laws. Make sure these devices do not exceed the voltage
capacity marked on the simple adaptor and on extension cords, and the maximum voltage marked on the multiple adaptor.
Check that the type of connection and voltage correspond with the information on the nameplate: see illustrations chapter figure 1.
For machines with a Y connection: see illustrations chapter figure 2.
For machines with a ∆ connection: see illustrations chapter figure 3.
For machines with a single-phase connection: see illustrations chapter figure 4.
WARNING
23