External On/Off Switch (Option); Door Contact (Option) - Tylo SENSE Combi PURE Série Notice D'installation

14
11. Fit the cover for the water reservoir, herb grille and fragrance
holder/air humidifi er (see Figure 13).
Fig 13: Fitting the cover for the water reservoir, herb grille and
fragrance holder/air humidifi er
12. Install the sensor on the wall see Fig 14 and 15. The thermi-
stor wire may also be passed through the wall see Fig 16A
and 16B. Seal any holes in the wall behind the sensor. The
thermistor wire may be extended outside the sauna using low
voltage wire (2-lead).
Figure 14: Installing the sensor - Combi Pure
Fig 15: Installing the humidity- and temperature sensor - Combi
Elite. The cable inside the sauna must be heat resistant.
Figure 16A: Wiring through the wall. The example shows the
sensor for Combi Pure.
Combi Pure
Fig 16B: Wiring through the wall. The example shows the sensor
for Combi Elite.
Unusual voltages/numbers of phases
Contact Tylö Customer Service before connecting to voltages or
Combi Elite
numbers of phases that are not listed in the wiring diagram Figure
17.

External ON/OFF switch (option)

The external ON/OFF switch can be positioned anywhere outside
the sauna, but not too far from the heater, to avoid voltage loss in
the cable. Voltage loss aff ects the LED indicator for heater status
(if built-in and connected to the switch).
For further information, see instructions supplied with the control
panel.

Door contact (option)

The door contact is necessary to be able to use the Pure panel's
preselected time or the Elite panel's calendar function, plus remo-
te control the sauna via external switch, mobile or PC apps.
See the instructions supplied with the control panel.