BH YF92 Mode D'emploi page 12

Then take the rear stabiliser bar (14)
and carry out the same assembly
operation as with the front stabiliser bar,
tighten up all of the nuts (11) securely.
4. ATTACHING THE SADDLE.-
Remove screws (19) and washers
(20) from the bottom of the saddle
(21). Fit the saddle (21) in the
direction of the arrow, Fig.4, onto the
saddle post plate (18), making sure
that the holes in the saddle post are
facing the front part of the saddle, and
tighten the nuts securely.
5. FITTING THE BACKREST
SUPPORT.-
Position de backrest "U" (22) in the
saddle post (18) Fig.5, fit the screws
(13) with the washers (20) and tighten
with the nuts (19).
6. FITTING THE BACKREST.-
Position the backrest (26) in the
support (25) Fig.6.
Fit it with the screws (27) and washers
(6) Fig.6.
Next, insert the saddle post (18) to the
hole Fig.7, on the main body (8), fit the
saddle post adjustment knob (17),
adjust the position of the saddle post
and tighten the knob (17) by turning it
clockwise.
7. FITTING THE SADDLE
HANDGRIP.-
Position the handgrip (23) in the
support (22) Fig.6. Insert the screws
(5), along with washers (6)(7) and nuts
(19) and tighten securely.
8. FITTING THE HANDLEBAR.-
Bring the handlebar (2) up to the
handlebar stem (8), slot as shown in
Fig.6, refit the screws (4), the washers
(5) and (6),
securely.
Remove the screws from the back of
the monitor, then place the monitor on
top of the main post in the direction of
the arrow, making sure not to pinch any
of the cables. Refit the screws and
tighten, connect the feedback terminal
at the back of the monitor, as shown in
Fig.10.
9. ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
damage the screw thread on the
pedal or the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right pedal (9) is marked with the
letter (R).This screws onto the right-
hand crank, also marked with an (R),
in a clockwise direction. Tighten
securely Fig.11.
The left pedal (16) is marked with the
letter (L).This screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction.
Tighten securely Fig.11.
10. EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control
(37), located on the main post, offering
various exertion settings, Fig.12.
To increase pedal resistance turn the
tensioning control (37) clockwise (+)
until the exertion level best suits your
exercise requirements. To reduce
pedal resistance turn the tensioning
control (37) anticlockwise (-).
12
Fig.9, and tighten