How to connect the input of the controller
The typical connections of the input of the TWISTORR 74 FS AG
On-board to an external system are described below. Two cases are
considered:
Note that a 24 Vdc, 30 mA voltage, a GROUND signal and the input
pins are available on the connector.
Figure 21
TwisTorr 74 FS AG On-board Controller User Manual / 87-901-054-01
1. the customer supplies the 24 Vdc
2. the customer does not supply the 24 Vdc.
Case 1 external power supply
Technical Information
J1 – IN-OUT
167/192
17