Agilent Technologies TwisTorr 74 FS AG Mode D'emploi page 154

Technical Information
Controller Installation
1
Turn the pump upside-down;
2
Place the L-shaped bracket (with external FAN)
on the pump bottom;
3
Place the square plate on the L-shaped bracket bottom;
4
Place the eight screws in the holes on the pump bottom;
5
Tighten the screws properly;
6
Turn the pump again;
7
Place the pump aligning the 4 holes of the square plate in the holes on the top of
the controller;
8
Place the four screws on the top of the controller;
9
Tighten the screws properly;
10 Plug the line cord and connect the pump cable
to the pump;
11 Connect the mating connector with the jumper
on the interlock signal to start the pump.
154/192 TwisTorr 74 FS AG On-board Controller User Manual / 87-901-054-01