Machine Operation (Scrubbing/Drying) - Clarke Vantage 17 B Mode D'emploi

Squeegee lifting
Lift the squeegee as indicated below:
1. Grasp the handlebar (2), lower it until the rear wheel (7)
touches the loor (A, Fig. 3) then engage the squeegee in
lifted position (B).

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the loor.
2.
3. If necessary, adjust the solution quantity by using the push-button (65).
CAUTION!
To avoid damaging the loor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the push-buttons (61).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the push-buttons (61).
NOTE
For correct scrubbing/drying of loors at the sides of the walls, Clarke suggests to go near the walls with the right side of
the machine as shown in igure 4.
CAUTION!
In case of brush/pad-holder motor overload, due to foreign bodies which prevent them from turning, or to
excessively aggressive loors/brushes, the safety system stops the brush/pad-holder after about one minute of
continuous overload.
The overload is shown by the three battery LEDs (64) lashing simultaneously.
To start scrubbing again after a brush/pad-holder stop due to overload, stop the machine by turning the switch
(62) to "0". Start the machine by turning the switch (62) to "I".
A A
INSTRUCTIONS FOR USE
Figure 4
9099650000 - VANTAGE 17 B
ENGLISH
c l i k
A
B
Figure 3
B
P100642
P100643
15