Machine Transport/Parking; Tank Emptying - Clarke Vantage 17 B Mode D'emploi

ENGLISH
Machine speed adjustment
The machine speed varies according to the type of loor to be cleaned and the choice of using the brush or the pad. If
4.
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
Battery discharge during operation
Until the green LED (64) turns on in the irst 5 seconds, the batteries allow to work normally. When the yellow and red LED turn
5.
on in sequence, it is necessary to charge the battery as the machine residual autonomy is at the minimum level.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.

MACHINE TRANSPORT/PARKING

To transport/park the machine, proceed as follows.
1. Turn off the machine by pressing the switches (62) and (63) to "0".
2. Lift the squeegee (59).
3. Engage the positioning pin (24) and activate the machine transport/parking device (23a) to keep the brush/pad-holder lifted
(Fig. 5).
4. While holding the machine in this position, drive it to the transport/parking area.
In order not to drag the brush/pad on the loor and leave wet marks, when inishing working, remove the brush/pad-holder from
5.
the deck by using the disengagement procedure (see the next paragraph), then place it on the front holder (43).
Brush/pad-holder removal
Remove the brush/pad-holder deck by performing the following procedure:
1. Turn the switch (62) to "I".
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Press the push-buttons (61) 3 times consequently, then wait that the brush starts and stop, thus disengaging from the drive
hub.
4. Turn the switch (62) to "0" position to switch off the machine.

TANK EMPTYING

An automatic loat shut-off system (46) turns off the vacuum system when the recovery tank (30) is full.
The vacuum system shutdown, due to the recovery tank illing, is signalled by an increase in the vacuum system motor noise,
moreover the loor is not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the loat is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by turning the switch (63) to "0", then
open the recovery tank cover (41) and check that the loat inside the grid (46) has gone down to the water level.
Then close the recovery tank cover (6) and turn on the vacuum system by turning the switch (63) to "I" position.
When the recovery tank (30) is full, empty it according to the following procedure.
16
INSTRUCTIONS FOR USE
VANTAGE 17 B - 9099650000
Figure 5
P100644