Angelo Po FX 82 G3T Manuel D'utilisation Et D'installation page 116

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Alarm
Fault
No water in chamber, or water
H2O
pressure too low
No water at drain, or water pres-
H2O.
sure too low
No mains gas, gas pressure too
low or flame detection failure
GAS
Oven door opening or closure
OPE
request
Indicates that cleaning is re-
CLE
quired
The cooking chamber probe
E01
has failed or is not properly con-
nected
The core probe has a failure or
E02
has not been properly connected
The steam discharge probe has
E03
failed
IT
The motor-operated valve is not
E04
GB
positioned correctly
DE
E05
Safety thermostat failure
FR
ES
E06
Overload cutouts tripped
E07
Power board failure
English
Remedy
Check that mains water is
present or adjust the pressure
(see page 61); if the problem
persists inform the after-sales
service
Check that mains water is
present or adjust the pressure
(see page 61); if the problem
persists inform the after-sales
service
Press reset button (the button
may have to be pressed several
times); if the problem persists
inform the after-sales service
Open or close the oven door
Inform the after-sales service if
this message continues to be
displayed
Launch an automatic cleaning
cycle
Inform the after-sales service
Check the position of the prod-
uct core probe or inform the af-
ter-sales service if it is faulty
Inform the after-sales service
Switch on the oven again and if
the problem persists inform the
after-sales service
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
- 50 -
Notes
Convection cooking cycles
can still be carried out
Convection and steam cook-
ing cycles can still be carried
out
Stop cooking if this message
is repeated more than once
The cooking cycle does not
start until the door has been
opened or closed as required
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Cooking cycles with product
core probe cannot be carried
out
Convection and steam cook-
ing cycles can still be carried
out
Convection and steam cook-
ing cycles can still be carried
out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Use and installation manual

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fx 82 g3ctFx 122 g3t1.302.01.06.01.28

Table des Matières