Residual Heat Indication; Booster Function; Timer - BORETTI BIK-79 Notice D'emploi

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still hot
and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Booster function

The booster function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work during 5 minutes with an ultra high power.
The booster is foreseen for example to heat up rapidly big quantities of water, like noodles cooking.

Start up / Stop the booster function:
Action
Zone selection
Start up the booster
Stop the booster

Power management:
The hole cooking hob is equipped by a maximum of power. When the booster function is activated,
and not to exceed the maximum power, the electronic system orders to reduce automatically the
power level of an other heating zone. The display is blinking on [ 9 ] during a few seconds and then
shows the maximum of power allowed :
Heating zone selected
[ P ] is displayed

Timer

The timer is able to be used simultaneous with all 4 heating zones and this with different time
settings (from 0 to 99 minutes) for each heating zone.

Setting and modification of the cooking time:
Example for 16 minutes at power 7:
Action
Zone selection
Select the power level
Select « Timer »
Set the units
Valid the units
Set the tens
Valid the tens
The time is confirmed and the cooking starts.

To stop the cooking time:
Example for 13 minutes at power 7:
Action
Zone selection
Select « Timer »
Deactivate the units
Valid the units
Deactivate the tens
Valid the tens
Control panel
press key [ 0 ] from the zone
press key [ P ]
slide on the "SLIDER"
or press on [ P ]
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Control panel
press display [ 0 ] selected
slide on the "SLIDER" to [ 7 ]
press display [ CL ]
slide on the "SLIDER" to [ 6 ]
press display [ 06 ]
slide on the "SLIDER" to [ 1 ]
press display [ 16 ]
Control panel
press display [ 7 ] selected
press key [ 13 ]
slide on the "SLIDER" to [ 0 ]
press display [ 10 ]
slide on the "SLIDER" to [ 0 ]
press display [ 00 ]
59
Display
[ 0 ] and control light on
[ P ]
[ P ] to [ 0 ]
[ 9 ]
Display
[ 0 ] and control light on
[ 7 ]
[ 00 ]
[ 0 fixed ] [ 6 blinking ]
[ 0 blinking ] [ 6 fixed ]
[ 1 blinking ] [ 6 fixed ]
[ 16 ]
Display
[ 0 ] and control light on
[ 13 ]
[ 1 fixed ] [ 0 blinking ]
[ 1 blinking ] [ 0 fixed ]
[ 0 blinking ] [ 0 fixed ]
[ 00 ]