Installation Procedure - Toto Oberon-R TL362SD Manuel D'installation Et D'utilisation

Masquer les pouces Voir aussi pour Oberon-R TL362SD:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.
Place gaskets under spout.
Pass the supply hoses and
mounting studs through the
mounting holes until the spout
comes to rest.
2.
Orient the spout as needed. From
below the mounting surface, place
the crescent shaped washer over the
mounting studs as shown.
Fasten the mounting nuts to the studs
to secure the spout.
Tighten with wrench as needed.
Connect the hoses to the supply lines.
The left hose (marked with red band)
connects to the hot water supply.
The right hose connects to the cold
water supply.
Tighten with wrench as needed.
3.
Insert the drain lift rod through the
opening in the back of spout.
NOTE: TL363SDA does not include drain
assembly or drain lift rod.
INSTALLATION PROCEDURE - Faucet
Washer
Mounting Nuts
4
Spout
Gaskets
Mounting Studs
Supply Hoses
Drain Lift Rod

Publicité

Table des Matières
loading

Table des Matières