Installation Procedure - Toto Soiree TS960F1 Manuel D'installation Et D'utilisation

inSTallaTion proCedure

HANDSHOWER INSTALLATION
Extension
Screw and Washer
Escutcheon
Handle
Setscrew
Hex Wrench
NOTE: Thoroughly clean and remove debris from the water supply pipe
before installation. This will prevent clogging the spray outlet.
Plumb 1/2" NPT nipple so that it extends between 3/8" and 7/8" from the
finished wall.
Slide the escutcheon off of the valve body.
Wrap adequate amount of pipe tape around the thread of the 1/2" NPT
nipple.
Thread the body onto the 1/2" nipple. Then tighten the cap so that the
packing is pressed against the wall.
Slide the escutcheon back onto the body and press it against the wall.
Operation Guide
counter-clockwise.
Packing
Cap
Body
Adapter
Showerhead
Hose
1/2" NPT Nipple
4
Finished
shower wall
1/2" NPT
Nipple
Finished
shower wall
3/8"
to 7/8"