Common Tools Needed; Installation Procedure; Care & Cleaning - Toto Guinevere TS970E Manuel D'installation Et D'utilisation

Set Screw
NO TE: Thoroughly clean and remove debris from the water supply pipe before
installation to prevent clogging the spray outlet.
1) Remove the set screw and slide the pipe connector out from the spout. Take care
not to damage the O-ring.
2) Wrap adequate amount of pipe tape around the thread of the 1/2" NPT nipple.
Install the nipple to the elbow. Make sure the 1/2" NPT nipple extends between
3/8" to 7/8" beyond the finish wall.
3) Wrap pipe tape onto the thread of the other end of the nipple and then thread
the pipe connector onto the nipple. Take care not to damage the O-ring.
4) Slide the spout onto the pipe connector. Take care not to damage the O-ring.
5) Secure the spout with set screw.
Your new showerhead is designed for years of trouble-free performance. Keep it
looking new by cleaning it periodically with mild soap, rinsing thoroughly with warm
water and drying with a clean, soft cloth. Do not use abrasive cleaners, steel wool or
harsh chemicals, as these will dull the finish. Failure to follow these instructions may
void your warranty.

COMMON TOOLS NEEDED

Pipe Tape

INSTALLATION PROCEDURE

Pipe Connector
with O-ring
Hex Wrench
CARE & CLEANING
Adjustable Wrench
1/2" NPT Nipple
Pipe Connector
with O-ring
4
Finished
Shower Wall
3/8"
to 7/8"