Angelo Po FX 61 G1/2 Manuel D'utilisation Et D'installation page 60

Alarm Fault
Indicates that cleaning is re-
CLE
quired
The cooking chamber probe
E01 has failed or is not properly con-
nected
The product core probe is not
E02
inserted in the food or has failed
The steam discharge probe has
E03
failed
The motor-operated valve is not
E04
positioned correctly
E05 Safety thermostat failure
E06 Overload cutouts tripped
The optional vacuum probe has
E08 failed or is not properly connect-
ed
IT
Electrical component compart-
E10
ment has overheated
GB
E11
DE
Electronic circuit board diag-
E13
nostics tripped
FR
E14
ES
E20 Setup error
The washing cycle has been in-
E23 terrupted during the final saniti-
zation stage
English
Remedy
Clean
Inform the after-sales service
Check the position of the prod-
uct core probe or inform the af-
ter-sales service if it is faulty
Inform the after-sales service
Switch on the oven again and if
the problem persists inform the
after-sales service
Inform the after-sales service
Inform the after-sales service
Press the "Reset" button
The oven solves the problem on
its own
Inform the after-sales service
Inform the after-sales service
Press the reset button and rinse
the cooking chamber thorough-
ly by hand.
Operate the oven in convection
mode to dry the cooking cham-
ber.
- 22 -
Notes
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Cooking cycles with product
core probe cannot be carried
out
Convection and steam cooking
cycles can still be carried out
Convection and steam cooking
cycles can still be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle.
If the problem persists, call the
after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
If the problem persists, call the
after-sales service
Use and installation manual