Angelo Po FX 61 G1/2 Manuel D'utilisation Et D'installation page 56

WASHING LEVEL 1 APPLIANCE
Caution - warning
Whenever the cooking mode is changed, clean
the chamber thoroughly.
To carry out this operation, proceed as follows.
1 – In STOP status press button (20) (icon (16) lit with
a green light).
The display (7) shows the message "CLE", the dis-
play (8) the message "Pr" and the display (9) the
message "P01".
2 – Press the button (16) (icon (16) lit with a red light),
and the display (7) shows the message "CLE" and
the display (8) shows the message "32'" (total wash-
ing time).
3 – When the beeper sounds (about 8 min. after
washing starts) and the "CLE" message flashes on
the display, place the detergent in the cooking cham-
ber.
4 – Open the door and spray the food-approved de-
tergent onto all the walls of the cooking chamber, the
heat exchanger and the fan.
Use of the "cleaner spray" accessory and the de-
tergent provided by the manufacturer is recom-
mended for this procedure.
Caution - warning
When cleaning and sanitising the appliance with
detergents, wear personal protection equipment
(gloves, masks, goggles, etc.) as required by the relevant health and safety leg-
islation.
5 – About 10 minutes after the detergent is added a beeper will sound and the dis-
play (7) will show "H2O". At this point open the door, rinse the cooking chamber
IT
by hand and dry it.
Use of the "washing spray gun" accessory is recommended for this procedure.
GB
Important
DE
Before cooking again, check that no detergent residues have been left in the
cooking chamber.. If residues are found, rinse the cooking chamber thoroughly
FR
by hand and heat the oven in "convection" mode for about 15 min. to dry it out.
ES
English
7
16
- 18 -
8
9
20
IDM-39619500100.tif
Use and installation manual