Cleaning The Condensation Collection Channel And Tank - Angelo Po FX 61 G1/2 Manuel D'utilisation Et D'installation

Table des Matières

Les langues disponibles

WASHING LEVEL 2 APPLIANCE

Caution - warning

Whenever the cooking mode is changed, clean

the chamber thoroughly.

To carry out this operation, proceed as follows.

1 – In STOP status press button (20) (icon (16) lit with

a green light).

The display (7) shows the message "CLE", the dis-

play (8) the message "Pr" and the display (9) the

message "P01".

2 – Press the button (16) (icon (16) lit with a red light),

and the display (7) shows the message "CLE" and

the display (8) shows the message "32'" (total wash-

ing time).

3 – When the beeper sounds (about 8 min. after

washing starts) and the "CLE" message flashes on

the display, place the detergent in the cooking cham-

ber.

4 – Open the door and spray the food-approved detergent onto all the walls of the

cooking chamber, the heat exchanger and the fan.

Use of the "cleaner spray" accessory and the detergent provided by the manu-

facturer is recommended for this procedure.

Caution - warning

When cleaning and sanitising the appliance with detergents, wear personal pro-

tection equipment (gloves, masks, goggles, etc.) as required by the relevant

health and safety legislation.

5 – Close the door and wait for the oven to complete the washing, rinsing and final

thermal disinfection program automatically. A beeper sounds at the end of the wash-

ing cycle.

Important

Before cooking again, check that no detergent residues have been left in the

cooking chamber. If residues are found, rinse the cooking chamber thoroughly

by hand and heat the oven in "convection" mode for about 15 min. to dry it out.