Truma MonoControl CS Instructions De Montage page 16

– Screw the outlet of the gas filter onto the regulator inlet, then se-
curely screw the high-pressure hose (with HRP) onto the inlet of
the gas filter. Make sure that the seals and thread are in perfect
condition.
Figure 4
– Check the hose connection at the inlet of the gas filter /
MonoControl CS for leaks (e.g. using a leak-finder spray in ac-
cordance with EN 14291).
– After installation, have the entire gas system checked by an expert
for leaks and proper installation.
– If there is a gas testing certificate, this must be supplemented or
changed accordingly.
This test does not replace the regularly scheduled gas check!
– All functions must then be tested in accordance with the operating
instructions.
– The operating instructions must be given to the operator.
EN
16