Dismantling And Disposal - Costan GRANVISTA NEXT Instructions Pour L'utilisateur

12. EMERGENCY SITUATIONS
1) The display case will not start or will not keep on working:
• there may be a general black-out;
• the wall main switch may be off.
If power failure is not due to any of the above causes, call the nearest after-sales service
immediately, empty the display case and store the foods in coldrooms or refrigerators that
may ensure preservation temperature.
2) The display case will not cool properly:
• make sure that the product load is correct and the air slots are not covered;
• defrost and clean it before starting normal operation (see chapter 11);
•make sure that the case is not exposed to sources of heat or draught;
•check that the display case is perfectly horizontal by the use of a spirit level. Make certain that
ambient conditions comply with the requirements of page 4.
Should insufficient cooling persist, resort to the nearest after-sales service.
3) The cabinet operates noisily:
•Make sure that screws and bolts are closed tight;
•Check that the display case is perfectly horizontal by the use of a spirit level.
IN CASE OF A GAS LEAK OR FIRE, do not breathe inside the room that houses the display case
before having aired it properly. Turn the display case off by the main switch ahead (see fig. 17).
DO NOT USE WATER BUT ONLY DRY EXTINGUISHERS TO FIGHT THE FIRE.
13. AFTER-SALES SERVICE
Should it be necessary to resort to technical assistance, contact your sales person immediately. If
spare parts are needed, always refer to your after-sales service: insist on the use of original
spare parts. Scroll the Italian and European network of branch offices on the back of this manual
for addresses and phone numbers.

14. DISMANTLING AND DISPOSAL

For the sake of the environment, please sort the parts and materials composing the display case
in accordance with the waste disposal provisions in force in your country, so that they can be pro-
perly disposed of or recycled. All its parts cannot be treated as household waste, except for the
metal parts, which nevertheless are not considered as special waste in most European countries.
THE PARTS COMPOSING THE REFRIGERATING CIRCUIT MUST NOT BE SEVERED OR SEPARATED
BUT DELIVERED INTACT TO A CENTRE SPECIALISED IN RECYCLING REFRIGERANT GAS.
15. SHELVES CONFIGURATION
To ensure the correct performance that the cabinet was designed for, shelves must be arran
ged inside the cabinet according to the set-up described on page 16. Shelf inclination can be
set on 4 different positions (0° - 7° - 14° - 21°), by moving the shelf supporting bracket on the
display case's uprights.
31