Setting Adjustment Indicators; Description - Cristec DC-DC YPOWER Série Manuel Utilisateur

( )
* This is a recommendation for installation rather than an obligation. The installing electrician should decide whether or
not to use shielded cable depending on the EMC environment.
3.3 -
SETTING ADJUSTMENT

3.3.1 Description

The YPOWER regulators are equipped with
the regulator according the battery type (see chapter 3.3.2.), Can
bus address (see chapter 3.3.9.) and special mode (see chapter
3.3.3.).
Normal Mode
Programming
Field 1
Programming
Field 2
Programming
Field 3
Programming
Field 4
Programming
Field 5
Programming
Field 6
Programming
Field 7
Store in memory + Normal Mode
-
INDICATORS
Press the "P" button for 1 second
Press"-"
N-1
Press the "P" button for 1 second
Press"-"
N-1
Press the "P" button
f 1 d
Press"-"
N-1
Press the "P" button for 1 second
Press"-"
N-1
Press the "P" button for 1 second
Press"-"
N-1
Press the "P" button for 1 second
Press"-"
N-1
Press the "P" button for 1 second
Press"-"
N-1
Press the "P" button for 1 second
buttons
to configure
Press"+"
N
Press"+"
N
Press"+"
N
Press"+"
N
Press"+"
N
Press"+"
N
Press"+"
N
N+1
Press the "+" and
"-"for 1 second
N+1
Press the "+" and
"-"for 1 second
N+1
Press the "+" and
"-"for 1 second
N+1
Press the "+" and
"-"for 1 second
N+1
Press the "+" and
"-"for 1 second
N+1
Press the "+" and
"-"for 1 second
N+1
Press the "+" and
"-"for 1 second
32