Selection Wheel And Switch Settings - Adjustment - Indicators; Description; Setting According To The Batteries Type - Cristec CPS3 12V/16A Manuel D'utilisation

3.3. SELECTION WHEEL AND SWITCH SETTINGS – ADJUSTMENT - INDICATORS

3.3.1. Description

The CPS3 chargers are equipped with a selection wheel (RC1) allowing to set up the charger
according the battery type and the application.
Setting thanks to a small flat head screw driver (width 2,5mm) and turn in clockwise direction.
The CPS3 chargers are equipped with a Boost function for a faster charge of the batteries. This
function is controlled by a timeout (see table here after) and is automatically inhibited when the
battery is fully charged : stoppage of the boost for I batteries < 15% of I rated charger.
For chargers CPS3/12-16, CPS3/12-25, CPS3/12-40 and CPS3/24-20, the Boost function can be
disabled by using the RC1 selection wheel (setting B,C,D or E).
For chargers CPS3/12-60, CPS3/24-30 and CPS3/48-15, the Boost function can also be disabled by
means of a switch (SW1). Setting by selecting the switch :

3.3.2. Setting according to the batteries type

(*) Voltage on BAT 1 / BAT 2 with 10% of the rated current and a tolerance of +/- 1%.
The voltage on +BATD is lower than 0,2V (approx.) at 10% of the charger rated current and 0,4V (approx.) at
100% of the charger rated current.
The voltage on +SP is higher than 0,3V (approx.) at 10% of the charger rated current and 0,4V (approx.) at 100%
of the charger rated current.
CPS3-1M-2M-DED
22